NEC NP510WS WXGA LCD Projector - 2100 ANSI lumens

Your projector is setup and ready to display your presentation about 4 seconds after powering on, with the NEC Quick Start function. The Quick Power Off function stops the cooling fan immediately after turning off the power to the projector, which makes it possible to remove the projector quickly. For a rapid shut down, the projector can be turned off without powering off the projector using the Direct Power Off function and a power strip equipped with a switch and breaker.

Comparison with the NP610Comparison with the NP610The fixed short-focus lens enables ultra short distance projection. For an 80-inch screen, it is possible to project from a distance of 1.20 m for the NP610S and 1.28 m for the NP510WS respectively, so that the projector can be set on a desk in the classroom or used in a meeting corner.

The projector employs the Carbon Meter indicating the reduced amount of CO2 emissions in Eco Mode. Visually confirm the numerical value indicating the reduction in CO2 emissions in comparison with Normal Mode operation.

Security functionBy using passwords, the projector cannot be used by unauthorized persons. It is impossible to project an image unless the proper password is entered.

Since the main unit has a security chain opening, unauthorized removal of the projector is prevented by inserting the security cable or wire commercially available into the opening.

Multiple input/output terminals include analogue RGB, DVI-I(digital), video, and S-video. By using the DVI-RGB adapter, analogue RGB signals can be connected from two computers.

Connect a LAN cable to the LAN port (RJ-45) on the main unit of the projector to control the projector from a remote PC via the network; for instance, use the PC to turn the power to the projector on and off or switch input signals.

The projector´s WXGA panel (1280 x 800) displays the same wide- format WXGA resolution images such as laptop computers and DVDs.

The included Virtual Remote Tool utility software allows to operate the power on/off or switch inputs on the projector from your PC by using the supplied VGA signal cable. The Easy Setup function is employed in addition to the ordinary Virtual Remote Tool. With this function, projector can be set up simply by following the instructions shown on the screen for easy setup.